If your cheekbones are the widest part of your face and your forehead and jaw are both narrower, the right haircut can change how your whole face reads. These diamond face shape hairstyles male readers look for most all work on one simple idea: add a little width where your face is narrow, and keep volume away from your cheekbones.
A diamond face is one of the less common shapes, so most generic advice is not written for you. The ten cuts below are picked for this exact shape.
How to Tell You Have a Diamond Face Shape
A diamond face has four clear signs. Your cheekbones are the widest measurement on your face. Your forehead is narrower than your cheekbones, your jaw is also narrower, and your chin is usually pointed rather than broad or flat.
Other shapes are easy to confuse with diamond. An oval face is longer than wide, with cheekbones only slightly wider than the forehead and jaw. A heart face is widest at the forehead. A square face has forehead, cheekbones, and jaw at almost the same width.
Measuring takes two minutes. Measure your forehead, cheekbones, and jaw at their widest points, and your face length from hairline to chin. Our measuring guide walks through each step with a soft tape and a mirror. A photo check is faster: the free face shape detector compares the same four measurements in seconds.
10 Best Hairstyles for Diamond Face Shape Male
You can also browse the full hairstyles page for more ideas, but start with these ten. Each one adds width at the forehead, the jaw, or both.
1. Textured Fringe
A textured fringe keeps hair forward over the forehead with choppy, separated ends, cut so it looks soft, not like a solid straight line.
It adds width exactly where a diamond face is narrow. The fringe fills out the forehead, which makes the cheekbones look less wide.
It suits men with straight or slightly wavy hair who want a low effort style. Barber tip: ask for the sides kept full, not faded tight.
2. Middle Part with Medium Length
A middle part with medium length hair falls to around the ears or just below them, parted in the centre so the hair frames both sides of the face evenly.
The longer sides add width at the jaw, the other narrow point on a diamond face. The centre part also draws the eye away from the widest cheekbone line.
It suits men with straight or wavy hair who are happy to grow some length. Barber tip: ask for light layers through the sides, no short back and sides, and keep length around the ears.
3. Layered Flow
Layered flow is medium to long hair cut in layers so it moves naturally and sits away from the face, longer on top and through the sides, with no harsh lines.
The layers create soft width at the forehead and the jaw at the same time, and the movement softens the sharp cheekbone line.
It suits men with wavy or thick hair who like a relaxed look. Barber tip: ask for the shortest layer no shorter than the cheekbone, and keep the sides long enough to cover the top of the ears.
4. Classic Side Part
A classic side part is short to medium on top, swept to one side from a clear part, with the sides kept neat but not tight. It is one of the oldest men’s cuts, and it still works.
The swept top adds volume across the forehead, while the side part creates a diagonal line that breaks up the symmetry of wide cheekbones.
It suits almost every hair type and men who want a smart cut for work. Barber tip: ask for a low taper on the sides, not a skin fade, and keep at least two inches on top so the sweep has weight.
5. Textured Crop with Fuller Sides
A textured crop is short on top with choppy texture, but the version for diamond faces keeps the sides fuller than a standard crop. The top is usually one to two inches long.
The texture adds width at the forehead, and the fuller sides stop the cut from narrowing the face at the temples. A standard crop with tight sides does the opposite.
It suits men with straight or wavy hair who want a short, easy cut. Barber tip: ask for a low taper with scissor cut sides, and say clearly: no skin fade and no tight sides.
6. Medium-Length Layered Cut
A medium-length layered cut keeps hair around four to six inches on top, with layers cut through the sides and back. It sits between a short cut and long flow.
The layers add gentle volume at the forehead and the jaw, the two narrow zones on a diamond face. The length also softens a pointed chin, which can look sharp with very short hair.
It suits men with wavy, curly, or thick straight hair who want versatility. Barber tip: ask for layers that start at the cheekbone and get longer toward the bottom, and do not thin the sides out.
7. Curtain Fringe
A curtain fringe parts the front hair down the middle so it falls like curtains on both sides of the forehead. The front is usually three to five inches long.
The two sides of the fringe widen the forehead visually, which is exactly what a diamond face needs, and it frames the cheekbones softly.
It suits men with straight or wavy hair and a bit of natural volume. Barber tip: ask for the sides left long enough to blend into the fringe, and let it fall naturally.
8. Side-Swept Fringe
A side-swept fringe pushes the front hair across the forehead to one side, usually with some length and texture. The sweep is the main feature of the cut.
The diagonal sweep adds width across the forehead and distracts from the wide cheekbone line. It is one of the easiest ways to balance a diamond face without growing long hair.
It suits men with straight or slightly wavy hair, and men with a higher forehead especially well. Barber tip: ask for length on top with a low taper on the sides, and part it on the side your hair already wants to go.
9. Messy Shag
A messy shag is a layered cut with lots of texture and uneven ends, worn loose and a little undone. The length is usually medium, around the ears or just past them.
The choppy layers add soft volume all around the face, at the forehead, the sides, and the jaw. Nothing in the cut is a hard straight line, so the sharp angles look softer.
It suits men with wavy or curly hair best, since the texture does most of the work. Barber tip: ask for layers cut dry if your hair is wavy or curly, and keep the length past the cheekbones.
10. Low Taper Fade with a Textured Top
A low taper fade keeps the fade very low, near the ears and neckline, while the top stays textured and medium in length. The sides above the taper stay full.
The low taper keeps width at the temples and cheekbone level, while the textured top adds width at the forehead. A high or skin fade would remove that width.
It suits men who like a clean fade but need the balancing width. Barber tip: ask for a low taper, not a mid or high fade, and keep two to three inches of textured length on top.
Hairstyles to Avoid for Diamond Faces
Some popular cuts fight a diamond face. Skin fades and very tight sides are the biggest problem: they remove width at the temples and make the cheekbones look wider.
Very tall styles are also a poor match. A high pompadour or tall quiff adds height where you do not need it. If you like height, keep it low and textured.
A buzz cut is another one to skip. With almost no hair to balance the face, the wide cheekbones and pointed chin are fully exposed. A short cut can still work, but it needs texture and fuller sides.
Long, flat, straight hair with no layers is also unhelpful. It hangs past the cheekbones and adds no width anywhere, so the face looks longer. If you want length, add layers. Slicked back styles with tight sides have the same issue: they pull hair away from the forehead, which is already the narrowest part of the face.
Quick Comparison
| Cut | Best for | Avoid if |
|---|---|---|
| Textured fringe | Straight hair, low effort | Very short hair |
| Middle part | Thick hair | Very fine hair |
| Layered flow | Wavy hair, relaxed look | Neat formal cut |
| Classic side part | Most hair types | Daily combing |
| Textured crop | Short cut, straight hair | Very fine hair |
| Medium layers | Wavy hair, versatility | Short cut |
| Curtain fringe | Straight hair, volume | Very flat hair |
| Side-swept fringe | Higher forehead | Centre part |
| Messy shag | Wavy hair, casual style | Neat tidy cut |
| Low taper fade | Fade lovers | High skin fade |
Final Thoughts
The right cut for a diamond face does one job: it balances wide cheekbones by adding width at the forehead and the jaw. Pick the one that fits your hair type and how much styling you want to do each day.
If you are not sure about your shape, check it first before you book the cut. Read the Diamond face shape guide to see the full picture, including glasses and beard advice. Then take one cut from this list to your barber, and use the exact words from the barber tip so you get the version that works for your face.
FAQs
1. What is the best hairstyle for a diamond face shape male?
The best all round choice is a textured fringe or a middle part with medium length. Both add width at the forehead and the jaw, the two narrow points on a diamond face. If you want short hair, pick a textured crop with fuller sides and a low taper.
2. Can men with diamond faces have short hair?
Yes, but the sides matter more than the length on top. Keep the sides full and ask for a low taper instead of a skin fade. A short textured crop works well, while a buzz cut usually does not, since it exposes the wide cheekbones with nothing to balance them.
3. Does a beard suit a diamond face shape?
Yes, a beard can help a lot. A fuller beard at the jaw adds width where a diamond face is narrow. Keep the sides full and the cheek line natural, and avoid a beard that is tight on the cheeks and long only at the chin.
4. Should I get a fade with a diamond face shape?
A low taper fade works well, but a high fade or skin fade usually does not. The low taper keeps the sides full around the cheekbones, while a high fade removes that width and makes the cheekbones look wider. Always say “low taper” to your barber.
5. What haircut makes cheekbones look less wide?
Any cut that adds volume at the forehead and the jaw makes cheekbones look less wide. A textured fringe, curtain fringe, or layered flow all do this. The rule is simple: add width where your face is narrow, and keep volume away from the widest part.
6. How do I know if I have a diamond face shape?
Measure four things: forehead width, cheekbone width, jaw width, and face length. You have a diamond shape if your cheekbones are the widest measurement and both your forehead and jaw are narrower. You can also check with a free face shape detector from a photo in seconds.
Diamond Face Shape Hairstyles Male: Choosing Your Next Cut
If you are still deciding, the best diamond face shape hairstyles male are the ones that add width at the forehead and jaw while keeping the sides fuller than a tight skin fade. Bespoke Unit’s diamond face shape guide explains the same balance — volume at the forehead and jaw, fuller sides — and it is a useful second opinion before you book. When you compare diamond face shape hairstyles male, start with a textured fringe or a middle part, then ask your barber to keep the taper low, which is what makes diamond face shape hairstyles male look balanced rather than top-heavy.
A good way to test diamond face shape hairstyles male is to try the style for a few weeks before committing to a shorter version, because length at the sides is what creates the balance. Many of the diamond face shape hairstyles male in this guide work with straight, wavy or thick hair, so choose the version that suits your hair type and how much styling time you want each morning. If you want a low-maintenance choice among diamond face shape hairstyles male, a textured fringe is the easiest place to start, and a middle part is the best longer option.
Before your appointment, save a photo of the cut you want and show it to your barber, because a clear reference helps with diamond face shape hairstyles male more than a long description. That one step makes it much easier to get the diamond face shape hairstyles male result you actually wanted.